產品簡介 / PRODUCT BRIEF

雨停高效好潔麗墻面固化底漆是采用優質特細徑的丙烯酸合成樹脂乳液精制而成，能有效

滲入墻體深層增強附著力，在外墻表面形成致密的耐堿性涂層，封固性強。

The YUTING good wall lepideus primer is made of high quality superfine size acrylic 

synthetic resin emulsion can be effectively refined, Deep into the wall to enhance the 

adhesion, the alkali resistance coating to form a dense outer surface, strong sealing 

performance.

產品特點 / PRODUCTION CHARACTERISTICS

封閉性好，能減少面漆免受基層化學物品的侵蝕

滲透能力優異，能有效提高層間附著力

優良的耐水性能，能保證面漆的附著性能，同時可節省面漆和改善涂膜光澤

流平性好，施工方便

增強膩子層牢固度

Good sealing ability. It can reduce the corrosion of the topcoat from the base chemicals

Excellent penetration ability, can effectively improve interlayer adhesion Excellent water 

resistance, can ensure the adhesion of the topcoat, while saving paint and improve coa-

ting gloss Leveling is good, construction is convenient Enhance the firmness of putty layer

適用范圍 / SCOPE OF APPLICATION

用于各種砂漿面、混凝土等基面的封閉，特別適用于滲透力高的水性涂裝體系使用，能有

效提高層間附著力。

The utility model is used for sealing the base surfaces of various mortar surfaces, co-

ncrete, etc., and is especially suitable for the water coating system with high penetra-

tion forceInterlayer adhesion.

施工指導 / ConTRUCTION GUIDANCE

基層要求：基層要堅固、平整、清潔、干燥（含水率≤10%）、中性（pH值≤10 )。

施工方式：刷涂、輥涂、噴涂

稀釋：直接施工，不建議稀釋

清洗：工具使用完畢，請立即用清水洗干凈

施工條件：施工溫度5-35℃，空氣濕度不大于85%，大風天氣及下雨季節應避免施工。

Basic requirements: basic level should be firm, smooth, clean and dry (water content 

less than 10%), neutral (pH = 10).

Construction methods: brushing, roll coating

sprayingDilution: direct construction, no dilution is recommended 

Cleaning: after the tool is used, please wash it with clean water immediately Construction 

conditions: construction temperature of 5-35 degrees, air humidity is not greater than 85%, windy 

weather and rainy season should avoid construction.

技術參數/TECHNICAL DARAMETER

理論涂刷面積：0.1-0.125kg/m/遍（實際用漆量會因施工方法、表面粗糙度等因素影響而有較大差異）

光澤：高光

干燥：表干≤2小時，實干7天/25℃

重涂時間：≥4小時（25℃，50%相對濕度）

Theoretical brushing area: 0.1-0.125kg/m/ times (the actual amount of paint will be due to const-

ruction methods, surface roughness and other factors and there is a big difference)

Gloss: high 

glossDry: dry work less than 2 hours, 7 days /25 C

Recoating time: 4 hours (25 DEG, 50% relative humidity)

注意事項 / MATTERS NEEDING ATTENTION

施工時應保持空氣流通，應遠離陽光直射及熱源；

如沾染眼睛，立即用大量清水清洗，并到醫院治療；放置在兒童取不到的地方。

Construction should keep the air circulation, stay awayfrom direct sunlight and heat source;

 If infected with eyes, wash immediately with plenty of water, and to the hospital for treatment; 

Place where children can't get it.

產品包裝 / PACKING OF PRODUCT

15kg/桶    15kg/barrel

10kg/桶    10kg/ barrel